AquaArm Topguard | MYK Arment Topguard | MYK Arment Aquarm Topguard | MYK Topguard | Acrylic two componant Topguard material for waterproofing in Pune and Pimpri Chichwad | Looking for AquaArm Multicrete waterproofing chemical in Pune & Pimpri Chinchwad you are at right place known as Elite Infra. Contact 82087 39490
Product Description :
AquaArm TopGuard is a cementitious, polymer dispersion based flexible protective coating and waterproof barrier. This product is two-component and resistant to water, moisture and abrasion. Its liquid component is solvent free. AquaArm TopGuard is a stand-alone product. It can be top or over coated with flexible or rigid mortars or coatings for uniform appearance.
Uses
• Balconies, Chajjas
• Toilet / Bathrooms
• Roof & Terraces
Features & Benefits:
• Breathable
• Flexible
• Self-Curing
Step no 3: Product Application
The mix material is to be applied on the prepared pre wetted surface (SSD conditions) in 2 coats. The 1st oat should be applied horizontally and the second coat should be applied vertically after 6-8 hours @ 30ºC of the first coat. AquaArm TopGuard to be applied typically at 1.5 - 2.5 kg/m². (subject to application requirement).
By brush:
The application of AquaArm TopGuard is a simple brush application. Use should be hard bristle brush.
Curing of AquaArm TopGuard:
AquaArm TopGuard is self-curing under normal condition The coated substrate/area can be exposed to: -Rain, vertical surface after approximately 4 hours @30°C temp -Rain, horizontal surface after proximately 12 hours 30°C temp - Foot traffic after approx. 2 days 30°C temp
Step no 1: Surface Preparation:
The substrate/surface must be sound, clean and allow a good surface adhesion so that the material can bond well into the concrete. Horizontal areas should have a rough surface. Smooth surfaces must be mechanically abraded in order to achieve good Bonding. Clean the surface to remove all loose particles.
Repair to be done for all cracks, honeycombs & blemishes from the concrete surface. Floor & wall Joints to be treated with SealArm Joint Tapes.
Step no 2: Product Mixing
AquaArm TopGuard comes in a pre-weighed composite bag of powder as Component A and Polymer liquid as Component B. They should be mixed in the ratio of 3:1 parts by weight in a clean container with the help of a slow speed drill (350-400rpm) fitted with a paddle arrangement. The material should be mixed for 3-4 minutes till a homogeneous mix is achieved which is free of any lumps. The powder has to be added to the liquid slowly (never add liquid to powder). Over mixing should be avoided.
